HOME

Click on Part Number for Dimensions and to Order

CHRYSLER Solid Pinion Bearing Spacer

SOLID PINION BEARING SPACER WITH SHIM PACK
8.75 (#489)   Part Number: 4103
7.25             Part Number: 4114
8.25             Part Number: 4114
9.25  Rear Axle Only  Part Number: 4109
Viper            Part Number: 4116

pinspacerwithshims.gif (66770 bytes)

 

 

SOLID SPACER INSTALLATION INSTRUCTIONS:

                             1. Measure the used Crush Sleeve that was originally in the housing. (if not available start with 3 shims)

                             2. Add enough Shims to the spacer to achieve a total length that is slightly longer than the used Crush Sleeve.

                             3. Install Spacer and torque the Pinion Nut to 125 foot pounds.  At this point pinion pre-load should be loose.

                             4. Remove the Spacer and Shims. Reduce this Shim Pack in .002 thickness increments and install until the proper bearing pre-load is achieved.

.010 -1  .020 .020     .036 .016,.020
.012 -2   .022 .010,.012    .038 .010,.012,.016
.016 -1  .024 .012,.012   .040 .012,.012,.016
.020 -1   .026 .010,.016   .042 .012,.010,.020
  .028 .012,.016    .044 .012,.012,.020
  .030 .010,.020   .046 .010,.016,.020
  .032 .012,.020    .048 .012,.016,.020
  .034 .010,.012,.012   .050 .010,.012,.012,.016